The frame has been extensively sculpted, the toplever is bench made, as is all of the peripheral metalwork. The rib extension slot is no longer a simple rectangular slot but a wide rounded mortise, into which is fitted a Boss-style rib extension. I've hidden all of the screws on the gun, the triggerguard (and the heel and toe plates, when they're made) are attached without screws at all.
I have no "before" photos of the gun but since it's a Utica Sterly, most will know what it looked like.
You'll probably also notice that the inside of the gun has received as much attention as the outside (as any custom gun would). The gun was featured in the July/August 2016 issue of Shooting Sportsman Magazine. https://shootingsportsman.com/crafting-hot-rod-sterlingworth/
This gun will also have an articulated front trigger. Here are some photos of the fabrication. I did cheat and used a ready-made screw to retain the spring.
The gun had gold plated triggers when it came to me, they will not be going back into the gun.
The cutter that was used to cut the mortise (with the standing post in the center) for the trigger's shoe portion is also bench made.
In its original configuration, the action knuckle relief must be there to allow the gun to open but I always thought that the notch spoiled the look of the gun, especially when viewed from the side.
I also want a completely smooth, uninterrupted surface on the bottom of the frame. So, to that end....
The problem -
While making the pattern stock, I took the opportunity to experiment with an idea for this project that had been in the back of my mind (and in my sketchbook) for some time. It looked pretty on paper but in three dimensions... I wasn't very happy with the results.
During the finishing phase, the internal parts will be gold plated, not for "bling" but for corrosion protection and lubricity. As I stated earlier, the internals are finished to a level that the manufacturer never reached. Here is a look.
The actual stock and forend are made. I had originally thought about installing the triggerguard without screws and I've decided against it. To quote Guido Rizzini, "A well aligned slotted screw embedded in the steel of a gun raises its aesthetic like a diamond in a jewel." Who am I to argue with possibly the greatest gunmaker in the world today? The guard is screwed down and the screws will be lockscrewed. The photos are below.
The internal parts are gold plated.